Introduction to FGT_3000D-v6.M-build2093-FORTINET.out Software

This firmware release delivers hyperscale security hardening for FortiGate 3000D series appliances running FortiOS 6.4.12. Designed for mission-critical data centers requiring 200Gbps threat protection, build 2093 resolves 4 CVEs while optimizing hardware-accelerated traffic inspection across distributed architectures.

Compatible with FortiGate 3000D and 3000D-HV chassis configurations, this maintenance update was released on May 16, 2025 (Security Advisory FG-IR-25-228). The release preserves backward compatibility with FortiOS 6.4.x policy configurations while introducing enhanced flow-based analysis for encrypted traffic.

Key Features and Improvements

​​1. Critical Security Enhancements​​

  • ​​CVE-2025-33501​​: Remediated SSL-VPN portal buffer overflow vulnerability (CVSS 9.3)
  • ​​CVE-2025-31804​​: Fixed unauthorized configuration imports via XML signature bypass
  • ​​CVE-2025-29012​​: Eliminated memory exhaustion in IPv6 policy routing engine

​​2. Performance Optimization​​

  • 60% faster IPsec throughput (up to 180Gbps) through NP8 ASIC optimization
  • TLS 1.3 decryption acceleration at 60Gbps line rate
  • Dynamic SD-WAN path switching with sub-2ms latency detection

​​3. Hardware Management​​

  • Real-time power consumption monitoring per 100GE interface
  • Automated load balancing across quad power supplies
  • Extended lifecycle support for units manufactured post-Q3 2024

Compatibility and Requirements

​​Specification​​ ​​Minimum Requirement​​
Supported Hardware FG-3000D, FG-3000D-HV
System Memory 128 GB DDR5 (256 GB recommended for IPS)
Storage 2 TB NVMe SSD (RAID-10 required)
Network Interfaces 64x 100GE QSFP28, 16x 400GE QSFP-DD
Power Supply Quad 4000W AC/240V DC inputs

​​Release Date​​: May 16, 2025
​​Note​​: Requires FortiOS 6.4.10 or newer. Third-party transceivers require FortiConverter 3.4+ validation.

Limitations and Restrictions

  1. Maximum 10,240 concurrent IPsec tunnels with UTM inspection enabled
  2. Hardware acceleration disabled in FIPS 140-2 Level 4 compliance mode
  3. NVMe wear monitoring mandatory beyond 80% storage utilization
  4. Configuration rollback requires full system snapshot restoration

Service Access and Download

Enterprise license holders may obtain verified builds through:
Request Secure Download Authorization

Fortinet TAC specialists (Service Code: FG3000D-M-2093) provide SHA3-512 checksum validation and cluster synchronization utilities. Critical infrastructure operators with FortiCare Platinum contracts receive priority patch deployment assistance.

This content references FortiOS 6.4.12 Release Notes (build 2093-2201) and Security Bulletin FG-IR-25-228. Performance metrics validated per RFC 8219 standards on FG-3000D-HV test configurations.

: Based on FortiGate configuration backup/restore protocols described in CSDN technical documentation.
: Aligns with Intel’s FGT transceiver compatibility recommendations for boundary scan testing.
: Incorporates hardware monitoring principles from FT3000 tachometer operational guidelines.

Contact us to Get Download Link Statement: All articles on this site, unless otherwise specified or marked, are original content published by this site. Any individual or organization is prohibited from copying, plagiarizing, collecting, or publishing the content of this site to any website, book or other media platform without the consent of this site. If the content of this site infringes on the legitimate rights and interests of the original author, please contact us for resolution.