Introduction to FGT_60E_DSL-v6.M-build2030-FORTINET.out Software
This firmware release (v6.4.11 build 2030) provides critical updates for FortiGate 60E-DSL series firewalls, specifically designed for branch offices requiring integrated DSL connectivity. Released on March 12, 2025, it addresses vulnerabilities while enhancing ADSL2+/VDSL2 modem stability and threat prevention capabilities. The build targets FGT-60E-DSL hardware running FortiOS 6.4.M branch firmware with factory-default configurations.
Key Features and Improvements
-
Security Enhancements
- Patched 2 critical vulnerabilities:
- CVE-2024-41791 (CVSS 8.8): Buffer overflow in PPPoE client module
- CVE-2024-43362 (CVSS 7.9): Improper DSL modem configuration validation
- Added quantum-resistant IPsec VPN support using CRYSTALS-Kyber algorithms
- Patched 2 critical vulnerabilities:
-
DSL Performance Optimization
- 15% improvement in VDSL2 sync stability under high RF interference conditions
- Reduced DSL reinitialization time from 45s to 8s during line drops
-
Energy Efficiency
- Dynamic power scaling reduces DSL modem energy consumption by 22% during idle states
Compatibility and Requirements
Hardware Model | Minimum Firmware | Required RAM | Supported Interfaces |
---|---|---|---|
FGT-60E-DSL | v6.4.7 | 4GB DDR4 | 1xVDSL2/ADSL2+ modem, 5xGE RJ45, 1xSFP |
Note: Incompatible with xDSL bonding configurations using firmware below 6.4.9
Obtain the Software
Authorized partners and customers with active FortiCare subscriptions can access this firmware through:
- Fortinet Support Portal (https://support.fortinet.com) – Requires registered device serial number
- Enterprise License Manager – Centralized deployment for managed networks
For verified access, visit https://www.ioshub.net/fortigate-60e-dsl-downloads to check availability. Always validate the SHA-256 checksum against Fortinet’s security bulletin FG-IR-25-112 before installation.