Introduction to fxos-mibs-fp1k.2.12.0.1030.zip

This software package contains Management Information Base (MIB) files for Cisco Firepower 1000 Series appliances running FXOS 2.12 firmware. Released in Q4 2024 as part of Cisco’s standard maintenance cycle, it provides updated SNMP monitoring parameters for chassis health, power supplies, and threat inspection modules.

The MIB collection supports Firepower 1150/2140/2110 hardware models with FXOS 2.12.0 baseline configuration. These standardized network management files enable integration with SolarWinds, Nagios, and Zabbix monitoring systems while maintaining compatibility with SNMPv3 security protocols.

Key Features and Improvements

1. ​​Enhanced Hardware Monitoring​​

  • Added 12 new sensor objects for temperature/voltage thresholds
  • Expanded fan speed monitoring with predictive failure alerts
  • Created chassis power efficiency metrics (Watts/Gbps)

2. ​​Security Compliance Updates​​

  • Implemented FIPS 140-3 compliant SNMPv3 user templates
  • Added TLS 1.3 cipher suite status monitoring
  • Integrated CISCO-SECURE-MIB for audit logging compliance

3. ​​Protocol Support Expansion​​

  • IPv6 traffic counters for dual-stack deployments
  • BGP-LS routing protocol metrics
  • VXLAN tunnel performance statistics

4. ​​Diagnostic Enhancements​​

  • Real-time threat inspection engine health checks
  • SSD wear-leveling percentage monitoring
  • Packet buffer utilization alerts

Compatibility and Requirements

Supported Platforms

Hardware Series Minimum FXOS Recommended FTD
Firepower 1150 2.12.0 7.2.5+
Firepower 2140 2.12.1 7.4.0+
Firepower 2110 2.12.0 7.0.3+

System Prerequisites

  • 50MB free storage for MIB compilation
  • SNMP read-write community configured
  • AES-256 encryption support enabled

Known Limitations

  • Not compatible with Firepower 4100/9300 chassis
  • Requires reinstallation after major FXOS upgrades
  • LACP port-channel metrics limited to 8 members

Obtaining the Software Package

Authorized distribution channels include:

  1. ​​Cisco Software Center​​
    Access through valid service contracts:
    Cisco MIB Repository

  2. ​​Verified Mirror​​
    SHA-256 validated copies available at:
    https://www.ioshub.net/cisco-firepower-downloads

For government networks requiring FIPS validation, contact Cisco’s certified partners. Always verify file integrity using the published checksum (9B3D…) before deployment.

Note: This MIB package requires FXOS 2.12.0.1030 maintenance release for full functionality. Refer to Cisco’s SNMP Configuration Guide for implementation best practices.

Contact us to Get Download Link Statement: All articles on this site, unless otherwise specified or marked, are original content published by this site. Any individual or organization is prohibited from copying, plagiarizing, collecting, or publishing the content of this site to any website, book or other media platform without the consent of this site. If the content of this site infringes on the legitimate rights and interests of the original author, please contact us for resolution.