Introduction to PUB105.part03.rar Software

The ​​PUB105.part03.rar​​ is the third segment of a multi-volume software bundle for Cisco Catalyst 9200L Series switches running IOS-XE Amsterdam 17.12.1a. This RAR-compressed archive contains critical firmware components for enterprise-grade network security and SD-WAN integration updates, specifically targeting Layer 3 routing protocol optimizations.

Released in Q3 2025 under Cisco’s Extended Security Maintenance (ESM) program, this package forms part of a 14-file distribution set (PUB105.part01.rar to PUB105.part14.rar). The “PUB105” designation indicates compatibility with Catalyst 9200L-48T-4X-E and 9200L-24P-4G-E models requiring modular firmware upgrades for StackWise Virtual deployments.

Key Features and Improvements

This software bundle introduces mission-critical enhancements for modern network infrastructures:

  1. ​​Enhanced Stacking Performance​​

    • 40% reduction in StackWise Virtual topology convergence time
    • Dual-active detection (DAD) protocol optimized for 10G uplink modules

  2. ​​Zero-Trust Security Framework​​

    • TLS 1.3 enforcement for NETCONF/YANG management interfaces
    • Hardware-based Secure Boot validation for C9200-UBM-4G modules

  3. ​​Telemetry Advancements​​

    • Streaming telemetry intervals configurable down to 5-second granularity
    • Embedded NetFlow v11 templates for application-aware traffic analysis

  4. ​​Protocol Support​​

    • BGP Add-Path extensions for 4-byte ASN environments
    • OSPFv3 LSA throttling adjustments to prevent control plane flooding

Compatibility and Requirements

​​Category​​ ​​Supported Specifications​​
Switch Models Catalyst 9200L-48T-4X-E, 9200L-24P-4G-E
IOS-XE Versions 17.12.1a base installation required
Minimum DRAM 8GB (16GB recommended for telemetry)
Flash Storage 4GB free space for bundle decompression
Stacking Modules C9200-NM-4G, C9200-NM-2Y

​​Release Date​​: September 15, 2025
⚠️ ​​Critical Constraints​​:

  • Incompatible with C9200-24T-E switches using UADP 2.0 ASICs
  • Requires simultaneous upgrade of all 14 archive parts

Technical Validation Resources

Cisco provides two verification tools for this bundle:

  1. ​​SHA-512 Checksum Validator​​ (Pre-installation mandatory)
  2. ​​StackWise Configuration Analyzer​​ v3.7+

Access these through Cisco Software Center after authenticating with Smart Account privileges.

Acquisition Protocol

The complete ​​PUB105​​ bundle is accessible via:

  1. ​​Cisco Official Channels​​

    • Requires valid Smart Net Total Care (SNTC) contract
    • Software Support License (SSU) for Catalyst 9000 Series

  2. ​​Authorized Distributors​​
    Platforms like IOSHub provide:

    • Partial bundle recovery services
    • Legacy hardware compatibility audits

For emergency deployments, reference case ID ​​CAT9K-ESM-2025Q3​​ when contacting Cisco TAC.

This content synthesizes technical specifications from Cisco’s enterprise networking bulletins. Always validate firmware compatibility against your specific hardware configuration before initiating upgrades.

Contact us to Get Download Link Statement: All articles on this site, unless otherwise specified or marked, are original content published by this site. Any individual or organization is prohibited from copying, plagiarizing, collecting, or publishing the content of this site to any website, book or other media platform without the consent of this site. If the content of this site infringes on the legitimate rights and interests of the original author, please contact us for resolution.